8/31/2023 0 Comments Pfsense wifi access point![]() The two devices on 10.1.1.0 network are statically defined. (I'm actually kind of surprised about that.) Here are the IPs of each of my AIO devices: The BASE AP11D is connected directly to the pfSense LAN port. I am not looking for help with pfSense config, but I would like recommendation/advice on what value I should use for the AIO MGMT and whether I should use this BRIDGE within pfSense or keep both LAN and LAN2 as two separate networks and use FW rules to allow them to interact with each other.Īs I mentioned, I currently have all of my devices up with the configuration above and it is working. However, I had some problems with getting all of my APs up. I was concerned that maybe VLAN tagging was causing some conflict between the AIO VLAN 1 and pfSense VLAN1, so I made some changes and played around with it. I had also set the MGMT VLAN to this same network using 10.1.1.0. I had assigned static IPs to all my devices on this. I am wanting to assign Static IPs, and was hoping to use the SWITCH as the AIO MGMT VLAN. It is in the current configuration, because of a lot of "hacking", and like I said, it is working, but I want to have a solid understanding of how it really should be configured and hope that I stop shooting myself in the foot with experimentation.Ģ) pfSense OPT (LAN2): 10.3.1.0/24 w/DHCPģ) pfSense SWITCH (bridge of LAN and LAN2): 10.1.1.0/24 w/DHCPĥ) AIO 1930 connected to pfSense LAN2 (OPT)Ħ) AP11D connected to pfSense LAN (as shown in diagram above) It is currently working, but I know that my configuration is incorrect and I am looking for guidance on how to properly configure my mgmt network. I have it pretty much set up and all my VLANs are configured and working properly. I settled on setting up my network, using the pfSense as the router to my network. ![]() I would really like if I could use the 1930 sw I am planning on building the following network primarily based on pre-existing cabling in my three-story house.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |